Evaluating the performance of the two-phase flow solver interFoam
Computational Science & Discovery, 5 (1):
014016+ (Nov 9, 2012)DOI: 10.1088/1749-4699/5/1/014016
Abstract
The performance of the open source multiphase flow solver, interFoam, is evaluated in this work. The solver is based on a modified volume of fluid (VoF) approach, which incorporates an interfacial compression flux term to mitigate the effects of numerical smearing of the interface. It forms a part of the C?+?+ libraries and utilities of OpenFOAM and is gaining popularity in the multiphase flow research community. However, to the best of our knowledge, the evaluation of this solver is confined to the validation tests of specific interest to the users of the code and the extent of its applicability to a wide range of multiphase flow situations remains to be explored. In this work, we have performed a thorough investigation of the solver performance using a variety of verification and validation test cases, which include (i) verification tests for pure advection (kinematics), (ii) dynamics in the high Weber number limit and (iii) dynamics of surface tension-dominated flows. With respect to (i), the kinematics tests show that the performance of interFoam?is generally comparable with the recent algebraic VoF algorithms; however, it is noticeably worse than the geometric reconstruction schemes. For (ii), the simulations of inertia-dominated flows with large density ratios yielded excellent agreement with analytical and experimental results. In regime (iii), where surface tension is important, consistency of pressure?surface tension formulation and accuracy of curvature are important, as established by Francois et al (2006 J.?Comput. Phys. 213 141?73). Several verification tests were performed along these lines and the main findings are: (a) the algorithm of interFoam?ensures a consistent formulation of pressure and surface tension; (b) the curvatures computed by the solver converge to a value slightly (10\%) different from the analytical value and a scope for improvement exists in this respect. To reduce the disruptive effects of spurious currents, we followed the analysis of Galusinski and Vigneaux (2008 J. Comput. Phys. 227 6140?64) and arrived at the following criterion for stable capillary simulations for interFoam: where . Finally, some capillary flows relevant to atomization were simulated, resulting in good agreement with the results from the literature.
